Aver ExpressGo Bedienungsanleitung PDF herunterladen (Seite 62)

 Map Network Drive

To add network storage, the Internet storage drive/folder must be mapped as Network Driver in DVR

server. Follow the below steps to map the network drive.

The ExpressGO doesn’t support the Map Network Drive function.

 Disconnect Network Drive

To disconnect the mapping network drive, click Disconnect Network Drive.

(11) System Controller Setup

To configure the parameters that is for communicating with the System Controller (an optional

accessory). For operating of the System Controller, please refer to user manual of System

Controller or download the manual from web site http://surveillance.aver.com/ .

 Enable – Mark the check box to enable the System Controller function.

 Upgrade – To update the firmware of the System Controller (see also Upgrading the Firmware of

the System Controller).

 Model – Select model of the System Controller. If System Controller is connecting to NVR

through the USB port, please select the System Controller Pro mode. If System Controller is

connecting to NVR through the RS485 port, please select the System Controller Pro 485 model.

 Port – Select the com port that is connected with the System Controller Pro.

Only when System Controller is using RS485 port connect to NVR server, the port needs to

be selected.

 ID – Set an ID for NVR server (0~99). This ID is a key for the System Controller to control the

NVR server when there are more than one NVR servers are connecting with the System

Controller through the RS485 port(see also Switch Control on Multiple DVR Servers).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 108 109

Keine Kommentare

Aver ExpressGo Bedienungsanleitung Seite 62